Loading...

Configure Network Settings for Multi-Tenant CommCell Environment

Complete the following steps to configure network settings for the multi-tenant commCell Environment:

Step 1: Configure Network Route Settings on the Commvault Proxy

In a multi-tenant CommCell environment, tenants must communicate with the service provider through a proxy computer.

When configuring the Endpoint solution setup wizard on the Command Center, you will assign a placeholder client for the proxy.

On the CommCell Console, set up the Commvault proxy and configure incoming and outgoing connections between the proxy and the CommServe computer.

For instructions, see Setting Up the Commvault Proxy for the Service Provider.

Step 2: Configure Network Route Settings on the CommServe Client

Configure network settings on the CommServe computer to specify incoming and outgoing connections for the proxy.

For instructions, see Configuring Network Route Settings on the CommServe Computer.

Step 3: Configure Access to Web Console

Configure the Web Console to communicate with the CommServe computer through the proxy.

For instructions, see Configuring Access to the Web Console Through the Commvault Proxy.

Last modified: 11/19/2018 4:01:53 PM