CommCell Management > Network > CommCell Network Requirements > IPv6 Requirements > Configuring IPv6 for Windows Computers > Enabling CommCell Communication Using IPv6 After Installation

Enabling CommCell Communication Using IPv6 After Installation

Use these steps to operate clients in an IPv6 environment after installing the software.

Note: These steps must be performed on each client after the software has been installed.

1. From the CommCell Browser, expand Client Computers.
2. Right-click the client > Properties > Advanced.
3. Click the Additional Settings tab, then click Add.
4. In the Name field, type nPreferredIPFamily.
5. In the Value field, type one of the following values:
   • 0 for IPv4 and IPv6 support
   • 1 for only IPv4 support
   • 2 for only IPv6 support
6. Click OK.
7. Restart the Commvault services.

Last modified: 5/2/2019 2:28:28 PM