Local Installation Using the Installation Package on UNIX Client

You can configure a direct connection from the CommServe computer to the client during a local installation using the Commvault installation package on a UNIX client.

Before You Begin

You must create a placeholder for the client that will receive connections from the CommServe computer. Follow the appropriate instructions based on the type of network route configuration:

• If you plan to use a predefined network topology, see Setting up a One-Way Direct Connection (CommServe to Client) Using a Predefined Network Topology. You must configure the topology and then create a placeholder.

• If you plan to use advanced settings, see Setting up Connections on the CommServe Computer.

Procedure

1. On the Network Configuration page of the installation wizard, select Yes, and then click Next.

2. Select CommServe can open connections toward us, and then click Next.

3. On the CommServe Client Name page, enter the name of the CommServe computer, and then click Next.

   Note

   Do not enter the IP or CommServe host name.

4. On the Port for CommServe to Open Tunnel to Client page, in the Local HTTP/HTTPS tunnel port number option, specify a local port number on which the client will receive communication from the CommServe computer, and then click Next.

5. Continue with the client installation.