You can restore an entire database after you deactivate the affected database. When you deactivate the database, all the db2 non administrative users will be disconnected. The system will automatically activate the database after the restore operation. However, you need to connect the non administrative users manually after the restore operation.
The Commvault software waits 2 minutes for the IntelliSnap operation to complete. If the job does not complete when this time expires, the Commvault software marks the job as failed and brings the database out of the quiesced state. You can set this to a higher value to allow more time for the job to complete. For more information, see Configuring the time the Commvault Software Waits for the IntelliSnap Operation.
Procedure
-
From the CommCell Browser, expand Client Computers > client > DB2 MultiNode > instance.
-
Right-click the backup_set, point to All Tasks, and then click Browse and Restore.
The Browse and Restore dialog box appears.
-
On the Time Range tab, select Latest Backup, and then click View Content.
-
Select the databases to restore, and then click Recover All Selected.
The Restore Options dialog box appears.
-
On the General tab, make the following selections:
-
Select the Restore Data check box.
-
Select Entire Database.
-
-
Click OK.