System Requirements for the Dell EMC VNX / CLARiiON Storage Array

Before you configure your storage array, verify that your environment meets the following requirements.

Licenses

Install the following licenses.

Use one of the following protocols.

Array	Protocol
Dell EMC VNX / CLARiiON	Fibre Channel Fibre Channel over Ethernet
Dell EMC VNX	Fibre Channel iSCSI

Use the following version and firmware.

Array	Version and Firmware
Dell EMC VNX / CLARiiON	CX500 / CX700 CX3-10-CX3-80 CX4-120-CX4-960
Dell EMC VNX	VNX 5100, 5300, 5500, 5700, 7500 VNX 5200,5400,5600,5800,7600,8000 For VNX snapshots, VNX OE for Block Version 05.32 or later

Install the following software.

Array	Required Software
Dell EMC VNX / CLARiiON	Solutions Enabler 7.6.2*, on the client and proxy computers Navisphere Host Agent on the client and proxy computers Client components (SYMCLI) are required only during the initial one-time configuration. Base components (with SYMAPI) are necessary and required for all snap operations
Dell EMC VNX	Solutions Enabler 7.6.2*, on the client and proxy computers Navisphere CLI on client and proxy (only for VNX snapshots) Navisphere or Unisphere Host Agent on the client and proxy computers Client components (SYMCLI) are required only during the initial one-time configuration. Base components (with SYMAPI) are necessary and required for all snap operations

Note

* Solutions Enabler 7.6.2 is the only supported version.

You do not need to open any specific port.