You can configure a direct connection from the client to the CommServe computer during an unattended installation using a custom package on a UNIX client.
Procedure
From the command prompt on the UNIX client, run the following command:
./silent_install -fwtype 0 -csclientname <CS clientname> -cshost <CS hostname> -tunnelport <tunnelport> -authcode <authcode>
Where:
-
fwtype 0means that this client can open a tunnel to the CommServe client (required) -
<CS clientname> is the CommServe client name (optional)
-
<CS hostname> is the CommServe hostname (optional)
-
<tunnelport> is the tunnel port of the CommServe client (optional)
-
<authcode> is the authcode of the CommCell or company (optional)
Note
If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.