You can configure a direct connection from the client to the CommServe computer during an unattended installation using a custom package on a Windows client.
Procedure
From the command prompt on the Windows client, run the following command:
Setup.exe /silent /play install.xml /fwtype 0 /csclientname <CS clientname> /cshostname <CS hostname> /tunnelport <tunnelport> /authcode <authcode>
Where:
-
fwtype 0means that this client can open a tunnel to the CommServe computer (required) -
<CS clientname> is the CommServe client name (optional)
-
<CS hostname> is the CommServe hostname (optional)
-
<tunnelport> is the tunnel port of the CommServe computer (optional)
-
<authcode> is the authcode of the CommCell or company (optional)
Note
If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.