To reset your cleanroom site, you can clean up all the recovered resources in a runbookâboth automatically and on demand. Cleanup is useful for cyber recovery testing and for restarting a cleanroom recovery operation when only some resources are recovered successfully.
Cleanup removes recovered resources from Commvault and changes the status of the recovered resources to Cleaned up.
Go to the runbook
-
In the Command Center navigation pane, go to Security services > Cleanroom.
-
On the Recovery groups tab, click the recovery group that contains the runbook.
-
Click the runbook.
Configure automatic cleanup
You can enable automatic cleanup of resources in a runbook and specify the number of days Commvault waits before cleaning up the resources.
When automatic cleanup is enabled, by default, resources are cleaned up 7 days after recovery on the production CommServe and 4 hours before CommServe expiry on the control plane CommServe.
-
On the Configuration tab, in the Cleanup options section, enable the Clean up entities after recovery toggle key.
-
For Cleanup interval (in days), click the edit button.
-
Enter the number of days after recovery to retain ther resources before cleaning them up.
-
Click Submit.
Clean up all resources on demand
-
On the Steps tab, in the upper-right area of the page, click Clean up.
-
Click Submit.
Clean up an individual resource on demand
-
On the Steps tab, expand the phase that contains the resource.
-
In the row for the resource, click the
, and then select Clean up.