You can install the custom package in interactive mode. This is useful if the package was configured to prompt for user input during the installation.
Note
The custom package includes a general package, and might also include native packages. Interactive installations apply only to general packages. If you want to install a native package, see Installing UNIX Native Packages.
Before You Begin
-
Obtain the custom package from the location specified by the user who created it.
If the package is in the Download Center, see "Downloading a Software Package" in Download Center - Web Console.
-
Based on the agents that are included in the custom package, verify that the computer on which you want to install the package satisfies the minimum requirements. For more information, see System Requirements.
-
If the custom package requires user input during the installation, but you did not create the package, the user who created the package will provide you with the necessary information to prepare for the installation.
-
If you have a 64-bit Linux computer and you want to protect 32-bit applications, you must create a lock file to enable 32-bit agent installations. For instructions, see "Alternate Method" in Enabling 32-Bit Installations on 64-Bit Linux Computers.
-
Certain clients, such as AWS, might require setting up a firewall connection between the CommServe computer and the client. Contact your AWS administrator or Commvault administrator for instructions on how to access the remote clients behind the firewall.
Procedure
-
Log on to the computer as root.
Note
If the computer does not have a root user defined, you can install some UNIX agents by using a non-root user. However, only a few agents are supported. For more information, see Installation of UNIX Agents by a Non-Root User.
-
Go to the location where you stored the custom package.
For example, suppose the custom package is located in the /opt/UnixCustomPackage directory. The package files are located in the /opt/UnixCustomPackage/pkg subdirectory.
If the package is in a .tar file (for example, /opt/UnixCustomPackage/tar), extract the contents using the GNU Tar utility.
-
To install the package, run the following command:
./cvpkgaddNote
If the custom package was configured to install the software in decoupled mode, you do not have to provide the CommServe computer details during the installation. In a decoupled installation, the client does not establish connections with the CommServe computer. At the end of the installation, you will receive a message indicating that the installation is not complete until you register the client with the CommServe.
Postinstallation Tasks
If the client was not registered during the installation, use one of the following methods to register the client:
-
Registering the Client Using the CommCell Console
If you do not have access to the console, a user with administrative rights in the CommCell must perform the registration for you.
-
Interactive End-User Edge Monitor Activation (only for Macintosh computers)