Unattended Installation Using a Custom Package on Windows Client

You can configure connectivity to the CommServe computer using a network gateway during an unattended installation using a custom package on a Windows client.

Procedure

From the command prompt on the Windows client, run the following command:

Setup.exe /silent /play install.xml /fwtype 1 /csclientname <CS clientname> /tunnelport <tunnelport> /authcode <authcode> /httpproxytype <httpproxytype> /httpproxyhostname <httpproxyhostname> /httpproxyport <httpproxyport>

Where:

  • fwtype 1 means that the CommServe computer can open a tunnel to this client (required)

  • <CS clientname> is the CommServe client name (optional)

  • <tunnelport> is the tunnel port of the local client (optional)

  • <authcode> is the authcode of the CommCell or company (optional)

  • <httpproxytype> is the HTTP proxy type, which can be one of the following integer values (optional):

    • 0: No HTTP proxy.

    • 1: Explicit HTTP proxy. If this value is used, then you must also include the following additional parameters:

      • <httpproxyhostname> is the hostname of the proxy.

      • <httpproxyport>- is the port number of the proxy.

      Example: Setup.exe /play install.xml /httpproxytype 1 /httpproxyhostname examplehost.commvault.com /httpproxyport 8403

    • 2: HTTP setting automatically taken from user profile.

    • 3: HTTP setting automatically taken from WPAD settings.

Note

If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.

Network Gateway in a Perimeter Network

Loading...