UpdateActiveMqPort

Description

This command is to modify ports where Message queue service is listening at.

For the change to take effect, corresponding change in registry setting must also be done.

Run the following command from Base using qlogin

qoperation execscript -sn UpdateActiveMqPort -si @clientName -si @tcpPort -si @AMQPPort -si @MQTTPort -si @StompPort -si @WSPort -si @webconsolePort

example - qoperation execscript -sn UpdateActiveMqPort -si client -si 8052 -si 8053 -si 8054 -si 8055 -si 8056 -si 8057

Usage

qoperation execscript -sn UpdateActiveMqPort -si @clientName -si @tcpPort -si @AMQPPort -si @MQTTPort -si @StompPort -si @WSPort -si @webconsolePort

Details

Scope: All
Platform: (Database: CommServ)
Release: 11.0.0

Disclaimer of Warranties

CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.