Verify that your environment meets the system requirements for SAP HANA.
Operating System
Important
Use the most recent version of the operating system that is listed. The Commvault software fully supports the most recent version of an operating system, until the vendor ends support. More recent versions of the Commvault software might not install on operating systems that are not supported by the vendor anymore. For information about the support lifecycle of an operating system, contact the vendor.
Commvault supports the following:
-
The 64-bit PowerPC architecture, ppc64le (or "little endian"). For SuSE Linux, Commvault supports the ppc64le PowerPC architecture on SuSE Linux 12 SP1 Enterprise Server and more recent versions.
-
IntelliSnap backups of multitenant databases on SAP HANA 2.0 SPS04 for Commvault Service Pack 17 and more recent versions.
-
Perform a database copy for both single database container and multi-tenant database container.
-
Database copy for different-named tenant databases for HANA 2.0 SPS01 and more recent versions.
-
SAP HANA Express 2.0 for Commvault Service Pack 7 and more recent versions.
-
HPE Serviceguard for Linux starting SAP HANA 2.0 SPS04. For setup, follow these steps:
-
Create a new Unix cluster client with its virtual client and add all appropriate physical nodes
-
Create a HANA pseudo client and add the Unix cluster client name.
-
SAP HANA 2.0 and Later Releases
Commvault supports SAP HANA 2.0 SPS07 with following exceptions:
-
When database/backup encryption is not enabled for the HANA SID.
-
When you enable encryption for the HANA SID, consider the following:
-
You should ask your SAP HANA database administrator to copy the required encryption keys to the destination computer before performing the restore operation. Commvault does not backup or manage the encryption keys.
-
To perform an in-place restore, verify that the encryption key is same between backup and restore.
-
To perform an out-of-place restore (database copy), copy the source key to the target SID before restoring the data. It is not needed to copy the encryption keys for subsequent restores unless the key on the source has changed.
-
|
Operating system |
Processor architecture |
|---|---|
|
Red Hat Enterprise Linux 9.x with glibc 2.34.x For SAP HANA for IntelliSnap, supported only on Commvault Platform Release 2023E and more recent releases. |
|
|
Red Hat Enterprise Linux 8.x For x64 processors, supported only on SPS04 or more recent versions. |
|
|
Red Hat Enterprise Linux 7.x For PowerPC (little endian) processors, supported only on SPS02 or more recent versions. |
|
|
SuSE Linux 12 (Initial Release/SP1 and later SPs) with glibc 2.19.x or a more recent version |
|
|
SuSE Linux 11 (Initial Release/SP1 and later SPs) with glibc 2.9.x and higher |
x64 |
|
SuSE Linux 11 SP4 Enterprise Server Download and install the mandatory patches from the SuSE site. |
|
|
SuSE Linux 15 (Initial Release/SP1 and later SPs) with glibc 2.26.x and higher |
|
Hard Drive
|
Component |
Space required |
|---|---|
|
Software |
2 GB |
|
Job results folder |
256 MB |
|
Log folder |
256 MB |
Memory (RAM)
2 GB or more
DISCLAIMER
Certain third-party software and service releases (together, "Releases") may not be supported by Commvault. You are solely responsible for ensuring Commvault’s products and services are compatible with any such Releases.