Creating a Recovery Group from a VM

You can replicate selected VMs by creating a recovery target and recovery group. VMs are backed up and replicated according to the settings in the recovery group.

You can replicate from streaming backups or VMware IntelliSnap backups:

When you configure replication for an individual VM, you can add VMs to an existing recovery group if one exists, or you can create a new recovery group.

Before You Begin

  • Verify that you have a source hypervisor and a destination hypervisor for the recovery group.

  • Review the configuration options for adding source and destination hypervisors, creating a recovery target, and configuring a recovery group:

  • Create a recovery target for the destination site.

  • For traditional replication, virtual machines must have been backed up at least once to be added to a recovery group.

    This requirement does not apply for snapshot replication.

  • For Amazon destinations, when replication uses an Amazon instance as the VSA proxy and does not specify a bucket, you must provide guest instance credentials for each guest instance on the Override options page for the recovery group, including the domain or computer name, username, and password.

Procedure

  1. From the Command Center navigation pane, go to Protect > Virtualization.

    The Virtual machines page appears.

  2. In the row for the VM, click the action button action_button, and then click Configure replication.

    The Select recovery group dialog box appears.

  3. Click Configure recovery group.

    The Configure recovery group page appears.

  4. On the Content tab, enter the required information for the source hypervisor, and then click Next.

  5. On the Target tab, enter the required information for the destination hypervisor, and then click Next.

  6. Configure the override settings for some VMs or use the same settings for all VMs:

    • To override settings for specific VMs, on the Override options tab, click Yes.

      1. To change the destination settings for specific VMs, from the Virtual machine list, select the VMs, and then under General Settings, configure the options you want to change.

      2. Click Next.

    • To use the same settings for all VMs, click No.

  7. On the Summary tab, review the settings you configured, and then click Finish.

Result

  • The configuration tool creates a replication schedule and a recovery group that includes the selected source VMs.

  • The properties page for a recovery group includes a Replication monitor that you can use to monitor the replication status and to perform operations.

Creating a Recovery Group from a VM Group

Loading...