Getting Started with the Fujitsu ETERNUS AF / DX Storage Array

To set up the Fujitsu ETERNUS AF / DX Storage Array, review system requirements, and then add the array in the Commvault software. Then you can modify the snapshot properties.

Procedure

1. Verify that your environment meets the Systems Requirements.

2. Run scripts and configure the array in the array console before configuring the array in the Commvault software:

   • Review best practices

   • Configuring Fujitsu ETERNUS AF / DX on the Array Console

3. On Commvault software, add and configure the Fujitsu ETERNUS AF / DX storage array in IntelliSnap Arrays page. See Setting Up the Fujitsu ETERNUS AF / DX Array Using Arrays Page.

4. To customize the array to your environment, edit the Snap Configuration Properties of Fujitsu ETERNUS AF / DX.

   Fujitsu ETERNUS AF / DX storage array is now ready to operate.

Where to Go from Here

Configure the destination volumes before any snap operation and choose one of the following agents to work in conjunction with the Fujitsu ETERNUS AF / DX storage array.

• Configuration of Destination Volumes

• Supported Agents