Loading...

HotAdd Restores

HotAdd Restores

HotAdd restores for Amazon provide faster performance than traditional restores. By using an access node (VSA proxy) that is running on an Amazon instance, the restore operation can write directly to Elastic Block Storage (EBS) and inject Amazon drivers that are required for destination instances.

HotAdd restores are used for the following operations:

  • Restores
  • Live sync operations
  • Conversion from VMware to Amazon, for the following VMware guest operating systems:
    • Windows Server 2019
    • Windows Server 2016
    • Windows Server 2012 R2
    • Windows Server 2008 R2

      Note: For VM conversion or live sync replication of guest VMs that run Windows Server 2008 R2, validation might fail for the converted instance in AWS. To resolve this issue, set the RealTimeIsUniversal registry key on the source VM as described in the AWS article Configuring Time Settings for Windows Server 2008 and later, and then perform a new backup to use as the source for the conversion or replication.

    • CentOS 7.x
    • RHEL 6.x
    • RHEL 7.x
    • Ubuntu 18.x

Requirements for HotAdd Restores

  • The Virtual Server Agent proxy selected for the operation must be an Amazon instance in the same zone as the destination instance.

Note: For cross-hypervisor restores or live sync replication from VMware to Amazon, you can use a VSA proxy that runs on Windows or Linux. If you use a VSA proxy that runs on Linux, for both Windows and Linux guest VMs, the drivers must be installed on the source before performing the backup.

Requirements for VM Conversion and Live Sync Replication Operations when Amazon is the Destination

For Windows guest VMs, you can copy drivers that are required for AWS instances to the access node (VSA proxy) that is used for conversion or replication operations. During the conversion or replication operation, drivers are automatically installed on the destination guest instances.

For Linux guest VMs, you must copy the required drivers to the source VMs and then perform a new backup to use as the source for conversion or replication operations.

HotAdd Restore Process

Windows:

  1. Create empty EBS volumes.
  2. Attach EBS volumes to proxy.

    Up to 21 volumes can be attached to the VSA proxy during cross-hypervisor restores or live sync replication, occupying device slots xvdf - xvdz.

  3. Restore data to EBS volumes.
  4. Inject AWS components and drivers.
  5. Detach volumes from the VSA proxy.
  6. Create the Amazon instance from the EBS volumes.
  7. Automatically log on to the instance to install PV drivers and EC2 configuration service.

Linux:

  1. Create empty EBS volumes.

    Up to 21 volumes can be attached to the VSA proxy during cross-hypervisor restores or live sync replication, occupying device slots xvdf - xvdz.

  2. Attach EBS volumes to proxy.
  3. Restore data to EBS volumes.
  4. Detach volumes from the VSA proxy.
  5. Create the Amazon instance from the EBS volumes.

Last modified: 7/15/2020 6:18:13 PM