Commvault HyperScale > HyperScale 1.5 > Appliance > Getting Started with HyperScale 1.5 Appliance > Setting up the HyperScale 1.5 Appliance

Setting up the HyperScale 1.5 Appliance

Choose a setup method based on your network topology:

Important: Determine the CommServe setup needed in your environment. During the setup you can setup the CommServe using one of the following options:

• Attach the nodes to an existing CommServe
• Setup a primary CommServe in the nodes
• Setup a standby disaster recovery (DR) CommServe in the nodes

  If you are setting up the appliance ...	Refer to
  With 10GigE data protection and storage pool network	Setting up the HyperScale 1.5 Appliance With 10G Data Protection and Storage Pool Network
  With 10GigE data protection and storage pool networks and a separate 1GigE management network	Setting up HyperScale 1.5 Appliance With 10G Data Protection and Storage Pool Network and 1G Management Network
  With a bonded 10GigE data protection and storage pool network	Setting up the HyperScale 1.5 Appliance with Bonded 10G Data Protection and Storage Pool Network
  With a bonded 10GigE data protection and storage pool networks, and a separate 1GigE management network	Setting up the HyperScale 1.5 Appliance with Bonded 10G Data Protection and Storage Pool Network and 1G Management Network
  With a 10GigE tagged VLAN link for data protection network and 10GigE StoragePool network	Setting up the HyperScale 1.5 Appliance with Tagged VLAN Link for the 10G Data Protection Network and a 10G Storage Pool Network

Last modified: 9/30/2019 6:50:18 PM