Loading...

Unattended Installation Using a Custom Package on UNIX Client

You can configure a direct connection from the client to the CommServe computer during an unattended installation using a custom package on a UNIX client.

Procedure

From the command prompt on the UNIX client, run the following command:

./silent_install -fwtype 0 -csclientname <CS clientname> -cshost <CS hostname> -tunnelport <tunnelport> -authcode <authcode>

Where:

  • fwtype 0 means that this client can open a tunnel to the CommServe client (required)
  • <CS clientname> is the CommServe client name (optional)
  • <CS hostname> is the CommServe hostname (optional)
  • <tunnelport> is the tunnel port of the CommServe client (optional)
  • <authcode> is the authcode of the CommCell or company (optional)

Note: If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.

Related Topics

Last modified: 9/5/2019 7:00:20 PM