Commvault HyperScale > HyperScale X > HyperScale X Appliance > Troubleshooting > Node is in Maintenance Mode After a Reboot

Node is in Maintenance Mode After a Reboot

Node appears to be in maintenance mode after a reboot.

Symptoms

You may see messages similar to the following during the boot sequence:

Resolution

1. Press Control-D to display the prompt.
2. Use the following command to switch to multi-user mode:

   # init 3

   The login prompt will be displayed. You can login to the node to troubleshoot the issue.

Last modified: 11/18/2020 4:17:52 PM