Deleting a Client

You can delete a NAS client by using the Command Line Interface.


  1. Run the qlogin command to log on to the CommServe computer.
  2. On the command line, run the following command:

    qdelete client -c <client_name>

    where client_name is the NAS client name.

    A message appears that says the command deconfigures and deletes the client and asks if you want to continue.

  3. Type n, and then press Enter.

    The client that you specified is deleted.

  4. Run the qlogout command to log off the CommServe computer.

Last modified: 4/24/2019 6:08:40 PM