Getting Started with the NetApp SolidFire Storage Array
To set up the NetApp SolidFire Storage Array, review system requirements, and then add the array in the Commvault software. Then you can modify the snapshot properties.
Step 1: Review Requirements
- Refer to the following information to learn more about the requirements for NetApp SolidFire storage array and supported agents:
- Systems Requirements
Step 2: Add and Configure the Storage Array in the Commvault Software
- On Commvault software, add and configure the NetApp SolidFire storage array in IntelliSnap Array Management. See Setting Up the NetApp SolidFire Array Using Array Management.
- To customize the array to your environment, edit the Snap Configuration Properties of NetApp SolidFire.
Step 3: Where to Go from Here
Choose one of the following agents to work in conjunction with the NetApp SolidFire storage array.
Last modified: 1/16/2019 11:00:58 PM