Command Line Interface - Client Computer Groups

Table of Contents

Configuring a Client Computer Group Using XML

qlist clientgroup

qmodify clientgroup

You can use the Command Line Interface to manage your client computer groups.

Configuring a Client Computer Group Using XML

Client computer groups can be updated using XML. The XML parameters can be part of the file, but in cases where the parameters frequently change, specify them on the command line.

  1. Download the update_client_computer_group_template.xml file to the computer from where you will run the command.
  2. Open the XML file and update the parameters as needed using the table below as reference.

    Parameter Table

  3. Save the changes to the XML file.
  4. Run the qlogin command to log on to the CommServe computer.
  5. From the command line, go to software_installation_directory/Base and type the following command:

    qoperation execute -af xml_path\update_client_computer_group_template.xml

    If the XML file is saved in the software_installation_directory/Base directory, the file path (xml_path in the example above) does not need to be included on the command line.

Last modified: 8/28/2018 3:22:09 PM