Loading...

Confirming the Successful Completion of the Disaster Recovery Operation

Disclaimer:
As of Version 11 SP10, Commvault does not sell the A600, A410 or the A210 Appliance anymore. You can purchase the Commvault HyperScale Appliance instead. For more information, see Commvault HyperScale Appliance.

After recovering the CommServe and the MediaAgent for Commvault Appliance A600, you must verify that the disaster recovery operation was successful.

Before You Begin

Ensure that the disaster recovery was run for the CommServe and the MediaAgent. For more information, see Recovering the CommServe and the MediaAgent for Commvault Appliance A600.

Procedure

  1. Log on to the server where the CommServe and the MediaAgent are installed.
  2. From Windows Explorer go to C:\DiskStorage and ensure that all the new LUNs are visible in this location.
  3. Log on to the Commvault CommCell Console and verify that all the mount paths are in the Online state.

    Note: It might take approximately 30 minutes for the Commvault CommCell Console to reflect the updated status for the mount paths.

    However, you can reduce this time by changing the value for the Interval (Minutes) between disk space updates configuration parameter.

    For more information, see Service Configuration.

What to Do Next

Restore and resynchronize the deduplication database (DDB) to bring the DDB online and revert it to a reusable state. For more information, see Resynchronizing the Deduplication Database.

Last modified: 3/1/2018 10:00:36 PM