Setting up a One-Way Direct Connection (CommServe to Client) Using Advanced Network Settings

You can configure the CommServe computer to establish direct connections toward the client.

If you do not want to use network topologies to configure your direct connection routes, you can use the Advanced network settings.

The advanced settings includes additional configuration steps, and is recommended for more experienced users. For example, you can configure incoming connection restrictions and ports.

Process Flow

  1. Set up the CommServe computer to open tunnel connections to the client. For instructions, see Setting up Connections on the CommServe Computer.
  2. Install the Commvault software on one or more clients. During a client installation, configure the client to initiate communications with the CommServe computer. For network settings instructions during the installation, see Setting Up Direct Connections from the CommServe Computer to the Client.
  3. Perform network configurations to establish incoming connectivity details between the CommServe computer, MediaAgent, and the client computer. For instructions, see Configuring the MediaAgent and Client.

Last modified: 10/4/2018 2:57:31 PM