Loading...

Adding a Microsoft Hyper-V Hypervisor

Add a Microsoft Hyper-V hypervisor to support data protection operations for all virtual machines hosted or managed by the hypervisor.

Before You Begin

  • Verify that the VSA package is installed on the CommServe computer.
  • Verify that the Hyper-V access nodes can communicate with the CommServe computer. If the access nodes reside behind a firewall, register the access nodes to the CommServe computer by installing the VSA package with the required firewall settings on each of the access nodes.

    Though you have registered these nodes to the Commserve computer, you must complete the entire procedure to add a hypervisor.

  • You will need the following information to add a hypervisor:
    • The hypervisor can be a Hyper-V cluster, a Hyper-V server in a cluster, or a standalone Hyper-V server.

      Be prepared to enter credentials for the Hyper-V server or cluster. The user must belong to the local administrators group for Hyper-V Server 2008 R2 or the Hyper-V administrators group for Hyper-V Server 2012 and later. For a Hyper-V cluster, the user account must have full cluster permissions (Read and Full Control).

    • Also identify one or more nodes on which you will install the VSA to create proxies for backup and restore operations.

Procedure

  1. From the navigation pane, go to Protect > Virtualization.

    The Virtual machines page appears.

  2. On the Hypervisors tab, in the upper-right corner of the page, click Add hypervisor.

    The Add hypervisor dialog box appears.

  3. For Select vendor, select Hyper-V.
  4. For Hostname/IP address, type the fully qualified domain name or IP address for the hypervisor.
  5. For Hypervisor name, type a descriptive name for the hypervisor.
  6. To provide access to the hypervisor, select one of the following:
    • Enter credentials: For Username and Password, type the user credentials to provide administrative access to the hypervisor.
    • Use saved credentials: For Credentials, select a credential from the list of those available.

      The credentials listed are applicable to this hypervisor.

      Note: To create a new credential (with Windows account type), to the right of Credentials, click Create new. Enter the name of the new credential and the user name and password to provide administrative access to the hypervisor. For more information, see Credential Manager.

  7. Click Discover nodes.

    Nodes will contain a list of discovered nodes.

  8. Select the nodes that you want to install the Virtual Server Agent on.

    For a Microsoft Hyper-V cluster, or to use Changed Block Tracking for Hyper-V 2012 R2, select all nodes in the Hyper-V cluster.

  9. Click Save.

Related Topics

You can install the Commvault System Center plug-in to manage backups and recovery of Hyper-V virtual machines from within System Center.

For more information, see Installing and Launching the System Center Plug-In.

Last modified: 3/7/2020 9:52:09 PM