Editing a Replication Group
After creating a replication group, you can modify the contents of the group.
For some options, you can make changes only when you are creating a new group or adding new VMs or instances.
Before You Begin
- Review the options for the destination hypervisor:
Procedure
- From the navigation pane, go to Disaster recovery > Replication.
The Replication groups page appears.
- Under Group name, click a group.
The replication group properties page appears.
- At the upper-right of the page, click Manage content.
The Edit replication group wizard displays the Content page.
- Provide the required information for the source hypervisor.
- Click Next.
The wizard displays the Target page.
- Provide the required information for the destination hypervisor.
Click Advanced options to configure additional parameters.
- Click Next.
The wizard displays the Override options page.
- Click Yes to override settings for specific VMs.
- To change the destination settings for specific VMs, select the VMs from the Virtual machine list, and then make the required changes.
- Click Next.
The wizard displays the Summary page showing the settings for the group definition.
- Click Finish to create the replication group.
Last modified: 10/28/2020 7:33:17 PM