Loading...

Getting Started with Commvault HyperScale Appliance

Review the following topics to get started with the Commvault HyperScale Appliance:

Step 1: What's in the Box

Ensure that you have received all the items in the shipment. For more information, see What's in the Box.

Step 2: Racking the Commvault HyperScale Appliance

Make sure that the Commvault HyperScale Appliance is racked as described in Racking the Commvault HyperScale Appliance.

Step 3: Cabling the Commvault HyperScale Appliance

Make sure that the Commvault HyperScale Appliance is cabled as described in Cabling the Commvault HyperScale Appliance.

Step 4: Pre-Installation Checklist

Collect the necessary information using the Pre-Installation Checklist to plan and prepare for setting up the Commvault HyperScale Appliance.

Step 5: Setting Up the Integrated Remote Management Console (iRMC)

Before setting up the Commvault HyperScale Appliance, setup the iRMC (Integrated Remote Management Console) on all the nodes. See Setting up the Integrated Remote Management Console (iRMC) for more information.

Step 6: Assigning Static IP If DHCP is Not Enabled

Assign static IP to the nodes, if DHCP is not enabled, as described in Assigning Static IP if DHCP is Not Enabled.

Step 7: Setting Up a Block

Setup a block consisting of 3 nodes as described in Setting up a Block to ensure that the correct nodes are identified and configured when the setup is subsequently run.

Step 8: Setting Up the Appliance

Setup the Commvault HyperScale Appliance. See Setting up the Commvault HyperScale Appliance for more information.

Step 9: Opening the Admin Console

Open the Admin Console using the URL that was added during setup. See Opening the Admin Console for more information.

Step 10: Completing the Core Setup

Core Setup includes the following tasks:

Step 11: Performing a Test Backup and Restore

Step 12: What to Do Next

After initial setup, you can perform the following tasks:

Last modified: 4/16/2019 6:58:47 PM