Loading...

Configuring SNMPV3

To send SNMP alert notifications, you must add the host name or IP address of the computer receiving the SNMP traps to the SNMP service.

Before You Begin

  • Install the CommServe SNMP Enabler software on the CommServe computer.
  • Install SNMP trap receiver software on the computers that will receive the SNMP traps sent by the CommServe.

Procedure

  1. From the navigation pane, expand Administration > Operations, and then click SNMPV3.

    The SNMP configuration page appears.

  2. Click Add configuration.

    The Add configuration dialog box appears.

  3. Enter the details for the trap destination computer.
  4. Click Save.

Last modified: 3/28/2019 7:50:05 PM