Loading...

Connecting To a CommServe Behind a Firewall During Setup

Hyperscale nodes must be able to connect to a CommServe during the initial setup. If the CommServe and the HyperScale nodes are separated by a firewall, additional configuration is required to establish the connection during setup.

Step 1: Create a pseudo client.

Step 2: Configure a one-way network route between the CommServe and the HyperScale client using a predefined network topology.

Step 3: Manually copy the network routes from the CommCell Console and create the FwConfig.txt file on the HyperScale Client.

Step 4: Register and manually start the Commvault Network Daemon service on the HyperScale Client.

Step 5: Register the HyperScale client.

Last modified: 4/22/2019 9:03:46 PM