Loading...

Enabling IPv6 Support During Software Installation

For each computer where you plan to install the software, open the command prompt and type the following command:

cvpkgadd -display-interface-family IPFamily_Value

Examples:

  • Use this command to apply both IPv4 and IPv6 support:

    cvpkgadd -display-interface-family 0

  • Use this command to apply IPv4 support:

    cvpkgadd -display-interface-family 1

  • Use this command to apply IPv6 support:

    cvpkgadd -display-interface-family 2

Last modified: 7/24/2019 5:44:15 PM