V11 SP8
Loading...

Configuring SnapVault with NetApp Command Lines

Before You Begin

Warning: You must configure SnapVault with the following command lines to avoid the risk of data loss.

Tips

  • You can use SSH or Telnet network protocols to access the storage device and the nodes of your topology to run the command lines in the procedure below.
  • To verify the licenses on your destination file server, type license.

Procedure

  1. If you are using NetApp 7.x or 8.x, then on the secondary file server, install the licenses:

    sv_windows_pri

    sv_linux

    sv_unix_pri

  2. On the secondary file servers, enable SnapVault by typing:

    options snapvault.enable on