You can perform a test failover operation to validate failover operations for a group of VMs.
For VMware destinations, a test failover operation live-mounts replicated VMs that are part of a failover group on the destination site. For Amazon, Azure, and Nutanix destinations, a test failover operation clones replicated VMs that are part of a failover group on the destination site.
Test failover is supported only for Amazon, Azure, Nutanix, and VMware destinations.
Before You Begin
-
Create a recovery target that includes virtual lab options.
-
Create a failover group that identifies the VMs to be included. The failover group must specify a replication target that supports test failover operations.
-
Verify that the failover group status is In Sync.
-
Make sure you have enabled validation for the VM group that you want to test and verify.
-
Make sure Warm site recovery is enabled for the VM group that you want to test and verify.
-
For VMware destination sites: To perform failover, test boot, and failback operations for VMware destination sites, VMware tools must be installed on the source VMs before replicating the VMs.
Procedure
-
From the navigation pane, go to Auto recovery > Replication groups.
The Replication groups page appears.
-
On the Failover groups tab, in the Name column, click a failover group.
The failover group page appears.
-
In the top-right area of the page, click Test failover.
A message appears and asks you whether you want to test the failover.
-
Click Yes.
Result
When the test failover operation completes successfully, the users who were configured to receive notifications for failovers receives an email notification that provides a summary of the test failover operation and a link that can be used to access the failover group.