To use the OnCommand Unified Manager server (OCUM) or Active IQ Unified Manager with the Commvault software, choose which version to install and then configure the OCUM server accordingly.
Choose the OCUM Version
Use the following table to decide which version of OCUM to install.
|
Goal |
Which version of OCUM to install |
|---|---|
|
Create SnapVault and SnapMirror copies of 7-Mode snapshots |
5.2, 5.1, or 5.0 |
|
Use Data ONTAP 8.1 |
5.1 or 5.0 |
|
Create SnapVault and SnapMirror copies of clustered Data ONTAP snapshot copies |
9.8, 9.7, 9.6, 9.5, 9.4, 7.3, 7.2, 7.1, 7.0, 6.4P1, 6.3P1, 6.2, 6.1 and 6.0, or Active IQ Unified Manager (AIQUM) 9.13*, 9.12*, 9.11*, 9.10, 9.9, 9.8, 9.7, and 9.6 Note The Active IQ Unified Manager (AIQUM) 9.14 and 9.13P1 are not supported. If you are using AIQUM-based replication, Commvault recommends verifying support from NetApp Interoperability Matrix for ONTAP 9.14.1, 9.15.1, and 9.16.1 with AIQUM 9.13* or older. For information on why certain AIQUM versions are not supported, see the NetApp KB articles CAIQUM-5577 and CAIQUM-6267. |
*The AIQUM version is supported only with specific NetApp patches. For information on the AIQUM version, see the NetApp article and contact NetApp.
To verify NetApp support for your product configuration, see the NetApp Interoperability Matrix Tool on the NetApp website.
Procedure
-
If you are going to use OCUM 5.x, then see High-Level Process Flow for OCUM 5.x.
-
If you are going to use OCUM or Active IQ Unified Manager with newer versions than 5.x, then see Configuring OCUM.