Description
Use this script to enable system state on all default subclients across the CommServe.
This script can take client name and backup set name as inputs. (Both are optional.)
If both inputs are given, the default subclient under system state backup is enabled on the given client and backupset and disabled on all its peer subclients. If only the client name is given, the same is done on all active backupsets under the client. When 'allclients' is used, the system state is enabled on all default subclients across the CommServe.
Usage
qoperation execscript -sn EnableSystemState -si allclients/c=clientName -si backupsetname
script_name : EnableSystemState
Use this script to enable system state on all default subclients across the CommServe.
This script can take client name and backup set name as inputs. (Both are optional.)
If both inputs are given, the default subclient under system state backup is enabled on the given client and backupset and disabled on all its peer subclients. If only the client name is given, the same is done on all active backupsets under the client. When 'allclients' is used, the system state is enabled on all default subclients across the CommServe.
Details
- Scope: All
- Platform: CommServe (Database: CommServ)
- Release: 11.0.0
Disclaimer of Warranties
CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.