You can configure a direct connection from the client to the CommServe computer during an unattended installation using a custom package on a Windows client.
Procedure
From the command prompt on the Windows client, run the following command:
Setup.exe /silent /play install.xml /fwtype 1 /csclientname <CS clientname> /tunnelport <tunnelport> /authcode <authcode> /httpproxytype <httpproxytype> /httpproxyhostname <httpproxyhostname> /httpproxyport <httpproxyport>
Where:
-
fwtype 1
means that the CommServe computer can open a tunnel to this client (required) -
<CS clientname> is the CommServe client name (optional)
-
<tunnelport> is the tunnel port of the local client (optional)
-
<authcode> is the authcode of the CommCell or company (optional)
-
<httpproxytype> is the HTTP proxy type, which can be one of the following integer values (optional):
-
0: No HTTP proxy.
-
1: Explicit HTTP proxy. If this value is used, then you must also include the following additional parameters:
-
<httpproxyhostname> is the hostname of the proxy.
-
<httpproxyport>- is the port number of the proxy.
Example:
Setup.exe /play install.xml /httpproxytype 1 /httpproxyhostname examplehost.commvault.com /httpproxyport 8403
-
-
2: HTTP setting automatically taken from user profile.
-
3: HTTP setting automatically taken from WPAD settings.
-
Note
If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.