Replication configuration includes Nutanix setup and Commvault configuration. You can configure the required Commvault entities individually, or all together using the replication group wizard.
Commvault Configuration
Commvault configuration includes the following entities:
-
Hypervisor configurations for the source and destination sites
-
Recovery target for each destination site
-
Replication group for virtual machines or instances that are replicated from the primary site to the secondary site
In addition, you can deploy access nodes in your environment to manage operations and MediaAgents to manage data movement. These entities are needed on the primary and destination sites.
Nutanix Hypervisor Configuration
For Nutanix, the Commvault hypervisor configuration represents a Nutanix node.
The following requirements apply:
-
Verify that the VSA package is installed on the CommServe computer.
-
Verify that the Nutanix nodes can communicate with the CommServe computer. If the nodes reside behind a firewall or if the CommServe server is running UNIX, register the nodes to the CommServe computer by installing the VSA package with the required firewall settings on each of the access nodes.
Though you have registered these nodes to the Commserve computer, you must complete the entire procedure to add a hypervisor.
-
You will need the following information to add a hypervisor:
-
The hypervisor is an Nutanix cluster.
Be prepared to enter credentials for the Nutanix cluster. The user must belong to the local administrators group for Hyper-V Server 2008 R2 or the Azure Stack HCI administrators group for Hyper-V Server 2012 and later. For an Nutanix cluster, the user account must have full cluster permissions (Read and Full Control).
-
Also identify one or more nodes on which you will install the VSA to create proxies for backup and restore operations.
-