You can can execute the VSA V1 to V2 Migration workflow on the CommCell Console to migrate virtualization clients from Indexing Version 1 to Indexing Version 2.
Note
-
When migrating a VSA client to V2 with this workflow, you cannot have a client group listed as an access node, or the migration will fail.
-
You cannot schedule this workflow to run at a user-defined time. The job will fail.
You can migrate only virtualization clients using this workflow.
Before You Begin
-
Review the information about supported hypervisors, what is not migrated, and limitations.
-
Run a full backup or synthetic full backup (whichever is applicable) prior to upgrading a virtualization client to Indexing Version 2.
-
Verify that the Workflow Engine is installed on the CommServe server.
-
From the Commvault Store, download the VSA V1 to V2 Migration workflow.
-
Stop all jobs on the virtualization clients that you want to migrate.
-
If you are backing up to tape media, you must have the last cycle's tapes on site before you migrate to Indexing Version 2.
Procedure
-
From the CommCell Browser go to Workflows, right-click VSA V1 to V2 Migration, point to All Tasks, and then click Execute.
The VSA V1 to V2 migration Options dialog box appears.
-
From the Run workflow on list, select the Workflow Engine that you want to use to perform the workflow.
-
To migrate all Indexing Version 1 virtualization clients to Indexing Version 2, leave both of the following check boxes selected:
-
Clone configuration from V1 client
-
Disable backup activity on the V1 virtual server agent post migration
-
-
To notify users in addition to the administrator when this workflow completes, in the Specify email addresses of any other users to be reported box, enter email addresses.
-
Click OK.