Use this dialog box to establish the storage device related settings on the selected subclient.
Data Transfer Option
Use this tab to establish the options for data transfer.
Software Compression
Indicates whether software compression for the subclient or instance is enabled or disabled, and if enabled whether it is performed on the client or MediaAgent computer.
On Client
Click to enable software compression on the client computer.
On MediaAgent
Click to enable software compression on the MediaAgent computer.
Off
Click to disable software compression.
Note that hardware compression has priority over the software compression. Hardware compression is established in the Data Path Properties dialog box. The above software compression option will take effect when the data path is associated with a disk library, or when hardware compression is disabled in the data path associated with tape libraries.
Note
If the subclient is associated with a storage policy copy that is deduplicated, then the compression settings on the storage policy copy takes precedence. See Copy Properties (Deduplication) - Advanced tab for compression settings on deduplicated storage policy copy.
Resource Tuning
Indicates the processes used by the client to transfer data based and whether bandwidth throttling is enabled or not.
Network Agents
Specifies the number of data pipes/processes that the client uses to transfer data over a network. Increasing this value may provide better throughput if the network and the network configuration in your environment can support it. The default value is 2 and a maximum of 4 can be established if necessary.
Throttle Network Bandwidth (MB/HR)
Specifies whether the backup throughput is controlled or not. (By default this option is not selected and therefore the throughput is not controlled). When selected, use the space to specify a value for the throughput. By default, this is set to 500. The minimum value is 1 and there is no limit to the maximum value. (In this case the backup throughput will be restricted to the maximum bandwidth on the network.)
Use this option to set the backup throughput, based on the network bandwidth in your environment. Use this option to reduce the backup throughput, so that the entire network bandwidth is not consumed, especially in slow links. Increasing this value will end up consuming the bandwidth with the maximum throughput limited to the network bandwidth capability.
Note that throttling is done on a per Network Agent basis.