QR Volume Creation Advanced Options

Updated

You can specify advanced QR Volume Creation options for the operation.

Specify Destination Volume

Specifies the physical volume to which the source is copied.

  • Source Volume

    Specifies the source volume.

  • Destination Volume

    Specifies the destination volume.

  • Dis-associate

    Click this to remove a destination volume for the selected source volume.

  • Destination Volume

    Select a destination volume from the dropdown list. QR Volumes and scratch volumes that are scheduled for use will not be selectable.

  • Apply

    Click this to associate the destination volume from the dropdown list to a selected source.

Specify Mount Point for Destination Volume

Specifies the drive letter or mount point to which the destination volume should be mounted after QR Volume creation.

  • Source Volume

    Specifies the source volume.

  • Mount Point

    Specifies the mount point or drive letter of the volume.

  • Dis-associate

    Click this to remove a mount point from the selected volume.

  • Mount Point

    Enter a mount point into this field. If the specified mount point does not exist or is already in use, the volume will not be mounted after the operation and a corresponding message will be displayed in the event viewer.

  • Apply

    Click this to associate the mount point you entered to the selected volume.

Mount destination Snap

For incrementally updated QR Volumes, when utilizing a QR Policy with Recovery Points enabled, mounts the latest Recovery Point to the specified mount point, instead of mounting the destination volume.

Was this page helpful?