Configuring the Dell PowerStore Storage Array using Arrays Page

For IntelliSnap backups from the Commvault software, add the Dell PowerStore storage array and configuration information to the CommServe database.

Before You Begin

You need to get the array service tag. You can find the service tag on the array software, in the Appliances section.
Verify that the credentials that you are going to use have the administrator role privilege or the storage administrator role privilege.
Verify that the subclient content is associated with only one PowerStore appliance. IntelliSnap backups are supported only if source volumes are associated with the same appliance.

From the navigation pane, click Manage > Infrastructure.

The Infrastructure page appears.
Click Arrays.
On the Arrays page, click Add.

The General page of the Add Snap Array configuration wizard appears.

From the Snap vendor list, select Dell PowerStore.
In the Array name box, enter the service tag.
In the Control host box, enter the cluster management IP address.
In the Description box, enter the description for the array.
For credentials, do one of the following:
- To use the saved credentials, move the Use saved credentials toggle key to the right, and then select credentials from the Saved credentials list.
- To add new credentials, enter the credentials in User name and Password boxes.
Click Next.

The Array Access Nodes page of the configuration wizard appears.

To configure additional MediaAgents to perform operations on the storage array, from the Available MediaAgents list, select one or more access nodes and then click OK.
- To select all the available MediaAgents as access nodes, click SELECT ALL.
To disable pruning, move the Pruning toggle button of the respective access node to the left.
To rearrange the selected access nodes, drag them upwards or downwards as required.
Click NEXT.

The Snap Configurations page of the configuration wizard appears.