To perform faster backups on data that resides on the Dell EMC Isilon/PowerScale File Server in the Command Center, you need to configure a NAS client, configure the storage array, and then configure a subclient. Then you can run a backup operation.
Procedure
-
Verify that your access node meets the hardware specifications to back up the CIFS shares and NFS exports.
-
Verify the following about your environment.
-
For CIFS shares using Windows access nodes, meets the system requirements for the Windows access nodes
-
For CIFS shares using Linux access nodes, meets the system requirements for the Linux access nodes
-
The samba-client or smbclient and the cifs-utils packages must be installed on the Linux access nodes if they are used to back up CIFS shares.
cifs-utils version
Operating System
What is backed up and restored
cifs-utils 6.2
Red Hat Enterprise Linux 7.x
DACL
cifs-utils 7.0
Red Hat Enterprise Linux 8.x
DACL and owner
cifs-utils 7.0
Red Hat Enterprise Linux 9.x - Kernel 5.11
DACL, owner, and SACL
-
-
For NFS exports, meets the system requirements for the Linux access nodes
You can back up NFS exports through HyperScale X access nodes as well.
HyperScale X version cifs-utils samba-client or smbclient HSX 3.x cifs-utils-7.0-1.el8.x86_64 samba-client-4.18.6-2.el8_9.x86_64 HSX 2.x (2.2) cifs-utils-6.2-10.el7.x86_64 samba-client-4.11.6-116.el7rhgs.x86_64
Note
-
For existing HyperScale X clients, Samba client and cifs-utils packages are automatically installed during the OS update to Commvault software Service Pack 36.
-
For new HyperScale X clients, Samba client and cifs-utils packages are automatically included in the Commvault software Service Pack 36 media.
-
-
Add the Dell EMC Isilon/PowerScale NAS File Server to back up CIFS shares, NFS exports, or NDMP backups.
-
Optional: Enable IntelliSnap backups for the Dell EMC Isilon/PowerScale subclient.
Note
CIFS backup using Linux access nodes is not supported with IntelliSnap.
-
Perform a test backup and restore