You can replicate a VM Group by creating a recovery target and recovery group. VMs are backed up and replicated according to the settings in the recovery group.
You can replicate from streaming backups or VMware IntelliSnap backups:
-
From streaming backups, VMs can be replicated to all supported hypervisors. For more information, see Cross-Platform Feature Support.
From VMware IntelliSnap backups, VMs can be replicated to VMware using VMware Continuous Replication Using VAIO.
When you configure replication for a VM group, you can add VMs to an existing recovery group if one exists, or you can create a new recovery group.
Before You Begin
-
Verify that you have a source hypervisor and a destination hypervisor for the recovery group.
-
Review the configuration options for adding source and destination hypervisors, creating a recovery target, and configuring a recovery group:
-
Create a recovery target for the destination site.
-
For traditional replication, virtual machines must have been backed up at least once to be added to a recovery group.
This requirement does not apply for snapshot replication.
-
For Amazon destinations, when replication uses an Amazon instance as the VSA proxy and does not specify a bucket, you must provide guest instance credentials for each guest instance on the Override options page for the recovery group, including the domain or computer name, username, and password.
-
For Hyper-V to Azure Stack Hub recovery groups, you cannot use VMs that contain user-created snapshots as a source for replication. Replication jobs fail if the source VM contains user-created snapshots.
Procedure
-
From the Command Center navigation pane, go to Protect > Virtualization.
The Virtual machines page appears.
-
On the VM groups tab, in the row for the VM group, click the action button , and then click Configure replication.
The Configure recovery group page appears.
-
On the Content tab, enter the required information for the source hypervisor, and then click Next.
-
On the Target tab, enter the required information for the destination hypervisor, and then click Next.
-
Configure the override settings for some VMs or use the same settings for all VMs:
-
To override settings for specific VMs, on the Override options tab, click Yes.
-
To change the destination settings for specific VMs, from the Virtual machine list, select the VMs, and then under General Settings, configure the options you want to change.
-
Click Next.
-
-
To use the same settings for all VMs, click No.
-
-
On the Summary tab, review the settings you configured, and then click Finish.
Result
-
The configuration tool creates a replication schedule and a recovery group that includes the selected source VMs.
-
The properties page for a recovery group includes a Recovery monitor that you can use to monitor the replication status and to perform operations.